Всем доброго времени суток! (Corona 16mb) Проблема такая припаял программатор Pico, начал через J-Runner считывать дамп, вылезло сообщение: "bad block detected in cell image area(0x00-0x50)
This may cause the console to not boot properly
if this occurs, replace the band stop chip and if needed, rebuild the image using the dnor band creator".
Дальше все делал по инструкции. И на моменте подключения к телевизору загорается зеленый диод питания а изображение не появляется. самое обидное что не сохранил оригинальный дамп.
Подскажите что можно сделать?
"J-Runner with Extras
Session: 12.20.2023 23:49:42
Version: 3.3.0 r2
Status: Up to date
Checking Console...
Flash Config: 0x00043000
Reading Nand to C:\J-Runner\output\nanddump1.bin
Read Successful!
Initializing nanddump1.bin, please wait...
Reading Nand to C:\J-Runner\output\nanddump2.bin
Glitch2 Selected
Nand Initialization Finished
Read Successful!
Comparing, please wait...
Bad Block ID 0043 Found @ 0x03FF [Offset: 0x107BE00]
Bad Block ID 033D Found @ 0x03FE [Offset: 0x1077C00]
Block ID 03FF [Offset: 0x107BE00] remapped to Block ID 0043 [Offset: 0x114600]
Block ID 03FE [Offset: 0x1077C00] remapped to Block ID 033D [Offset: 0xD5BA00]
Bad Blocks Remapped
Bad Block ID 0043 Found @ 0x03FF [Offset: 0x107BE00]
Bad Block ID 033D Found @ 0x03FE [Offset: 0x1077C00]
Block ID 03FF [Offset: 0x107BE00] remapped to Block ID 0043 [Offset: 0x114600]
Block ID 03FE [Offset: 0x1077C00] remapped to Block ID 033D [Offset: 0xD5BA00]
Bad Blocks Remapped
Nands are the same
RGH3 Selected
XeLL image created
Checking Console...
Flash Config: 0x00043000
Writing glitch.ecc to Nand
Write Successful!"